ChatterBox X1slim Installation Manual download pdf (Page 9)

1. For the open face headset, use the plastic tie clip to secure the windsock. For

the full face headset, microphone covers come pre-installed.

2. Helmets without speaker pockets. Attach the foam covers to the speakers

respectively (Drawing 1). Attach the hard velcro disk to the back of the speak-

ers (Drawing 2). Attach the soft velcro disks to the helmet liner. The position

of the soft velcro disks will determine the position of the speakers.

3. Attach the right speaker (the long cord) to the soft velcro disk that you

applied to the helmet liner. Attach the left speaker (the short cord) to the soft

velcro disk that you applied to the helmet liner. For helmets with speaker pock-

ets, simply insert the speaker in the pocket. Then use the wooden stick to gen-

tly tuck the speaker wire between the headliner and the shell (Drawing 3).

4. For full face headset. Attach the soft rectangular velcro piece to the chin bar.

Keep in mind the position of this velcro will determine the position of the mic.

Apply the mic to the soft rectangular velcro. Then use the wooden stick to gen-

tly tuck the mic wire between the headliner and the shell (Drawing 4).

1 2

HEADSET INSTALLATION

Headset Connection

Insert the Mini-DIN plug of the driver headset into the microphone speaker jack

on the back of the main unit. Insert the flat side of the main plug facing you.

Fasten the mounting bracket snugly to the bottom left side of the helmet with

the bolts supplied. Make sure the rubber pad is placed between the outer

mounting bracket and the outer shell of the helmet. Then align the mounting

bracket with the grooves on the back side of the main unit. Slide down the main

unit on to the mounting bracket until it latches firmly into place.

MAIN UNIT INSTALLATION

14 15

gmrsx1-owners-manual 2/24/04 1:59 PM Page 18

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

ChatterBox X1slim Installation Manual Page 9